Carefree of Colorado Installation Manual MANUAL PATIO AWNING
052876-105 3
ASSEMBLING THE AWNING
CAUTION
DO NOT REMOVE THE FOLLOWING ITEMS UNTIL INSTRUCTED TO DO SO IN THE INSTRUCTIONS. 1) TAPE AROUND
THE CANOPY
; 2) THE SAFETY PIN IN THE ROLL BAR (THIS IS HOLDING THE PRE-WOUND SPRING TENSION); OR,
THE
NYLON STRAP HOLDING THE ROLL BAR BRAKE LEVER. REMOVING THESE ITEMS PREMATURELY MAY
CAUSE PERSONAL INJURY
, DAMAGE TO THE AWNING AND CAUSE THE AWNING TO NOT OPERATE CORRECTLY.
Remote Lock
Spirit & Fiesta Only
1/4-20 x 7/16
Quadrex Drive
Screw
Left Arm Assy
Right Arm Assy
SF004
DETAIL A
Open Position
Spirit & Fiesta Only
Remote Lock
Storage Lock
1/4-20 x 7/16
Quadrex Drive
Screw
Figure 4. Assembling the Awning.
1. On a flat surface, layout the arms and rollbar assembly.
• Position the rollbar with the fabric oriented as shown over the top with the edge toward the coach.
The brake lever must be on the right side.
• For Spirit and Fiesta – The right arm assembly has the remote lock.
2. For All Models: Slide the left arm into the left end plug of the roll bar. Align the holes and secure using
one (1) 1/4-20 x 7/16 Quadrex Drive screw.
3. For Simplicity: Repeat step 2 for the right arm assembly.
4. For Spirit and Fiesta: Hook the remote lock over the brake lever while sliding the arm into the right end plug.
Align the holes in the arm and end plug and secure using one (1) 1/4-20 x 7/16 Quadrex Drive screw.
Tip: Release the travel lock and slide the remote lock up until it protrudes over the arm. Hook the
remote over the brake lever. Allow the remote lock to slide back into the channel while sliding the arm
into the end plug. R
EMEMBER TO CLOSE THE TRAVEL LOCK WHEN DONE.
5. Measure and confirm the width of the awning. The distance is measured from centerline of arm to
centerline of arm. (Refer to
Figure 2 on page 2.)
MOUNTING THE BOTTOM MOUNTING BRACKETS
1. On the awning rail, mark the position of the centerlines of the
arms. Ensure that the arms will not interfere with any lights,
vents or other obtrusions.
2. Using a non-permanent method of marking such as a chalk
line, mark a perpendicular line from the awning rail down to
the floor line. This is the centerline of the arms.
3. Position and attach the bottom mounting brackets. These should
be centered on the lines made in the previous step and
MUST be
attached to the structure at the floor line of the vehicle. Attach
using 1/4 x 2/12 lag screws.
NOTE: The bracket is made to straddle the trim found at the
floor line. A flat shim is available for mounting to flat
areas without trim. If it is necessary to space the
bracket out from the wall, a spacer bracket is available.
Shim and spacer must be ordered separately.
Optional Standoff
Optional Shim
Awning Arm
1/4 x 2 1/2 Lag Screw
SF005
Figure 5. Mounting the Bottom Brackets.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals